Logo

B1855 Engine Code Repair

Meaning of B1855 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B1855 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B1855 code is occuring now you should check B1855 repair processes.
Now don't ask yourself; What should you do with B1855 code ?
The solution is here :

B1855 Possible Solution:

B1855 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

B1855 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

1
Fuel And Air Metering

8
Fuel Rail Pressure Sensor Circuit Malfunction

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

5
Timing Reference High Resolution Signal A Too Many Pulses

Regarding the B1855 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B1855 OBD-II Diagnostic Body (B) Trouble Code Description

B1855 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For B1855 Code

The reason of B1855 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

B1855 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.